| NOTE: This method only works on open faced decals. |
| |
| 1. Clean area with soap and water solution. After you have cleaned the area, spray the soapy water liberally on the recessed area. Get it completely soaking wet with this dish soap water solution. |
 |
| |
| 2. Next carefully peel a letter off the backing sheet. Do NOT get the backing sheet wet. |
 |
| |
| 3. Lay the letter into the recessed area of the bumper. The soapy water solution will allow you to slide and maneuver the letter into place. |
 |
| |
| 4. Take a step back and look at how the letter is mounted. Step back up and re-adjust the letter if needed. You have a few minutes so take your time. The letter will fit into the recessed area, so not much adjusting will be needed. |
 |
| |
| 5. Carefully peel and apply each letter. Take your time. Continue to spray down the area with soapy water. Do not be afraid to really wet the area down. |
 |
| |
| 6. Here you can see each letter fits neatly into the recessed area of the bumper. |
 |
| |
| 7. Once everything is in place you can step back and check your work. Readjust any letters if you need to. Chances are that you will not, the letters fit into place easily. |
 |
| |
| If you notice any air bubbles, you can squeeze them out while the letters are drying. |
| |
| |
| Allow 24 hours for the letters to fully dry before blasting them with water, etc. You can drive your stang after the letters dry overnight. Hot weather or parking in the sun speeds up the drying time considerably |
| |
| Send pictures to pictures@custombrakelights.com so we can feature your car on any upcoming listings on eBay or changes to our website. |
